Daily maintenance of home used lamps and lanterns

2018-04-01 admin 3


Because of improper use of lamps and lanterns in later stage, lamps and lanterns may soon fail, which will bring great inconvenience to daily life. If you want to use it normally in the period of use of the lamps and lanterns, it is necessary to have a correct maintenance method for the lamp. The lamp master will take you to know what problems should be paid attention to in the daily use of the lamps.

1, lamps and lanterns must be used at preset voltage and frequency.

2, any grounding luminaire must check the grounding condition frequently.

3, if there are special restrictions and prescribed lamps, it is usually used at ambient temperature of 5-35 degrees.

4, indoor lamps and lanterns can not be moved to outdoor use.

5, electrical, gas, kerosene stove and other heater and its components or directly encountered steam place, should not use ordinary bulbs.

6. The light bulb that can not exceed the specified number of tiles in the lamp. If the light bulb power is less than the designed power, the light intensity can not reach the standard. If the power of the light bulb is larger than the designed power, it may cause the circuit to short circuit, and it will cause the fire more seriously.

7, looking for a professional lamp cleaning master for a year and 1-2 professional cleaning of the lamps and lanterns. At the same time, the professional master can find the installation screw and the anti shedding device without loosening and corrosion, such as loosening to tighten, if there is obvious corrosion phenomenon, it needs to be repaired or replaced.

8, when changing lights, dismantling lampshades and fuses, we must remember that we must cut off the power supply.

9, it is not possible to place articles such as paper and cloth near the illuminator or to cover the illuminator, so as to prevent fires caused by high temperature.

10, use warm water to scrub or wring dry soaping water cloth scrub lamps, can not use gasoline, volatile oil and other scrubbing.

11, the metal parts of lamps and lanterns can not be wiped with corrosive liquids, so as to prevent the destruction of metal protective films and rust.

12, when there are abnormal situations when using lamps, they should stop using, cut off the power and check.

13, regular maintenance and maintenance of the use of lamps and lanterns, welding in the use of chemical reaction, especially easy aging, these include the drive, welding, socket, screws, wires and so on. Replace the deformed, rusty parts.

14, check whether the lifting face or load-bearing surface is deformed or weighed enough. If there is need for reinforcement,

The life of the general lamps and lanterns is very long. If you can give a reasonable maintenance and replacement of the lamps and lanterns in use, it is believed that the lighting can maintain a good long state in the life period and ensure the safety of the user.